5. Remove the solid-state drive tray (3).
The solid-state drive tray and screws are included in the Solid-State Drive Hardware Kit, spare part
number 809859-001.
6. If it is necessary to replace the solid-state drive connector board, remove the two Phillips PM2.0×3.7
broad head screws (1) that secure the solid-state drive connector board to the solid-state drive tray.
7. Remove the solid-state drive connector board (2).
The solid-state drive connector board is available using spare part number 811608-001.
Component replacement procedures 31
To Next Page
Loading...
