e. Remove the WLAN antenna cables and transceivers (4).
The WLAN antenna cables and transceivers are included in the Antenna Kit, spare part number
809852-001.
18. If it is necessary to replace the WWAN antenna cables and transceivers:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the WLAN antenna cables and transceivers.
d. Detach the WWAN antenna transceivers (1) from the display back cover. (The WWAN antenna
transceivers are attached to the display back cover with double-sided adhesive.)
e. Release the WWAN antenna cables from the clips (2) and routing channel built into the left and
right sides and the bottom edge of the display enclosure.
Component replacement procedures 45
To Next Page
Loading...
