Hard drive
Description Spare part number
1.5-TB, 5400-rpm, 9.5 mm 747375-001
1-TB, 5400-rpm 778192-001
750-GB, 7200-rpm (HP 440 models only) 633252-001
750-GB, 5400-rpm, 7 mm hard drive 634250-001
500-GB, 5400-rpm 669299-001
500-GB, 5400-rpm, 7 mm, hybrid (8-GB SSD) 732000-001
500-GB, 7200-rpm 703267-001
320-GB, 5400-rpm 622643-001
128-GB Solid-state drive 767453-001
120-GB Solid-state drive (HP 440 models only) 768055-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 42).
5. Remove the large service door (see
Service door on page 43).
To remove a hard drive:
1. Remove the 4 Phillips PM2.5×4.0 screws (1) that secure the hard drive to the chassis.
2. Slide the hard drive (2) away from the center of the computer to disengage it from the connector.
Component replacement procedures 45
To Next Page
Loading...
