Function board
Description Spare part number
Function board 767443-001
Before removing the function board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 42).
5. Remove the following components:
a. Service doors (see
Service door on page 43)
b. Keyboard (see
Keyboard on page 55)
c. Hard drive (
Hard drive on page 45)
d. Optical drive (
Optical drive on page 49)
e. Top cover (see
Top cover on page 58)
Remove the function board:
1. Position the top cover upside-down.
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the function board to the top cover.
3. Slide the board toward the top of the top cover (2), and then lift it off the top cover (3).
Component replacement procedures 67
To Next Page
Loading...
