Optical drive
NOTE: All optical drive spare part kits include an optical drive bezel, bracket, and screws.
Description Spare part number
DVD-ROM drive 767440-001
Blu-ray ROM DVD±RW SuperMulti DL Drive (HP 440 models only) 768051-001
DVD±RW SuperMulti DL Drive 767439-001
Before removing the optical drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 42).
5. Remove both service doors (see
Service door on page 43).
Remove the optical drive:
1. Remove the Phillips PM2.5×6.0 screw (1) that secures the optical drive to the computer.
2. Push the optical drive tab (2) to release the optical drive from the computer.
3. Remove the optical drive (3) from the computer.
Component replacement procedures 49
To Next Page
Loading...
