Second webcam
NOTE: The second webcam cable is included in the Cable Kit, spare part number 917064-001.
Description Spare part number
Second webcam (includes cable) 917055-001
Webcam transfer board (includes cable) 917053-001
Before removing the second webcam, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 18).
Remove the second webcam:
1. Turn the keyboard/top cover upside down with the front edge toward you.
2. Remove the Phillips PM2.0×2.3 screw (1) that secures the webcam transfer board to the keyboard/
top cover.
3. Remove the two Phillips PM2.0×2.0 broad head screws (2) that secure the second webcam bracket to
the keyboard/top cover.
4. Remove the Phillips PM1.6×2.0 screw (3) that secures the second webcam to the keyboard/top cover.
5. Detach the second webcam cable (4) from the keyboard/top cover. (The second webcam cable is secured
to the keyboard/top cover with double-sided adhesive.)
6. Remove the second webcam bracket (5).
The second webcam bracket is included in the Bracket Kit, spare part number 917057-001.
Component replacement procedures 25
To Next Page
Loading...
