Audio board
Description Spare part number
Audio board (includes audio jack, volume control buttons, and cable) 917048-001
Before removing the audio board, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 18).
5. Remove the battery (see Battery on page 27).
Remove the audio board:
1. Release the ZIF connector (1) to which the audio board cable is connected, and then disconnect
the audio board cable from the system board.
2. Remove the Phillips PM2.5×3.0 screw (2) that secures the audio board to the bottom cover.
3. Release the audio board (3) by lifting the right side until it rests at an angle.
4. Remove the audio board (4) by sliding it up and to the right at an angle.
Reverse this procedure to install the audio board.
Component replacement procedures 33
To Next Page
Loading...
