3. Disconnect the wireless antenna cables (3) from the terminals on the WLAN module.
NOTE: The wireless antenna cable labeled “1/MAIN” connects to the WLAN module “Main” terminal.
The wireless antenna cable labeled “2/AUX” connects to the WLAN module “Aux” terminal.
4. Disconnect the webcam/microphone module cable (4) from the system board.
5. Disconnect the display TouchScreen cable (5) from the system board (only on computer models
equipped with a TouchScreen display assembly).
6. Release the wireless antenna cables, webcam/microphone module cable, and display TouchScreen cable
(only on computer models equipped with a TouchScreen display assembly) from the retention clip (6)
built into the bottom cover.
Component replacement procedures 39
To Next Page
Loading...
