Software Fixes
Release G.05.01
Switch. For example, for previous HP ProCurve switches, the US Pacific time zone was
configured by entering +480. With software version G.05.xx, the US Pacific time zone must
now be configured by entering -480.
Agent Hang (PR_4381) — Agent processes (such as console, telnet, STP, ping, etc.) may
stop functioning when the IGMP querier function is disabled, and then re-enabled, on a VLAN
that does not have an IP address configured.
Agent Hang (PR_4562) — Agent processes (such as console, telnet, STP, ping, etc.) may
stop functioning. This agent hang has been associated with the CERT SNMPv1 “encoding”
test #1150.
Agent Hang (PR_4805) — Agent processes (such as console, telnet, STP, ping, etc.) may
stop functioning. This agent hang has been associated with the X2 SSH utility.
CLI (PR_3786) — The CLI command “show arp” displays the wrong port number for some
ARP entries.
CLI (PR_3792) — The CLI command “show trunks” lists incorrect information for dynamic
trunks.
CLI (PR_3809) — The CLI command “getmib” with no parameters returns the message
“Incomplete input: - EOI -”.
CLI (PR_3895) — Unrelated information was shown at the end of the CLI command “show
vlan 1” output.
CLI (PR_3940) — Command “no qos” did not reset port priority to “0”.
CLI (PR_4108) — When reaching the inactivity timeout expiration after typing the CLI
command “enable” in a telnet session at operator mode, the text in the CLI prompt may get
corrupted with text similar to “gfs_alp_104Null Varbind”.
CLI (PR_4406) — The CLI command “show tech” causes an error message when the
command is executed from within config mode.
CLI (PR_4474) — The prompt for saving the config does not handle a DISC character
appropriately.
CLI/Timezone (PR_4524) — The switch time is wrong if CLI used to set timezone and
timezone may not operate properly after switch is rebooted. West of GMT is now a negative
offset and east of GMT is now a positive offset.
Crash (PR_3711) — When hot-swapping transceivers multiple times, the switch may crash
with a message similar to: -> Software exception at port_sm.c:378 in -- 'mPmSlvCtrl'
Crash (PR_4006) — If dynamic trunks are configured and the switch is rebooted, the switch
may crash with a message similar to: ->Software exception at rstp_dyn_reconfit.c:243 in --
'Lpmgr'
17
To Next Page
Loading...
Need help?
General