Software Fixes
Release G.05.01
Event Log (PR_3964) — Log messages for trunks and trunk members enhanced to be
easier to read.
GARP/Event log (PR_4238) — GARP event log messages may be garbled.
IGMP (PR_3248) — Interoperability issues with some Cisco devices (such as some Cisco
Catalyst 5000 & 6000 series switches) cause IGMP groups to be aged out of the switch's IGMP
tables prematurely.
LACP/802.1x (PR_3868) — 802.1x and LACP trunks can co-exist on the same port. [Fix is
to make these trunks mutually exclusive.]
LACP (PR_3954) — LACP maintains a dynamic trunk with only 1 port configured for the
trunk group.
Menu (PR_2259) — The switch may not display the complete forwarding table while
performing a MAC address search.
Menu (PR_2926) — Incorrect error message is displayed when attempting to create a VLAN
which exceeds the maximum number of VLANs supported. [Fix is to display an error message
similar to “Maximum number of VLANs (8) has already been reached.”]
Menu (PR_3024) — Menu does not allow a port configuration change from a full- duplex/
flow control setting to a half-duplex/no flow control setting.
Menu (PR_3509) — Menu does not allow trunks to be configured on transceiver ports that
have never had a transceiver installed before.
Menu/CLI (PR_3920) — Modified help message for RSTP.
Menu/VLAN (PR_3975, 3976) — The VLAN help text has been modified
Module Crash (PR_4229) — A module may crash with a message similar to: -> Assertion
failed: soc->soc_link_pause >0,f
NNM/Stacking (PR_4556) — If stacking is configured, NNM cannot discover the device
as a generic switch.
STP Fast Mode (PR_4659) — A port configured for STP fast mode behaves like a standard
STP port.
STP/RSTP (PR_4170) — Port path cost is reset even though path cost is configured for
“Auto”.
STP/Running-Config (PR_4488) — STP path-cost is not written to the configuration when
using the CLI.
STP/Startup-Config (PR_4141) — When a startup-config file containing an 802.1d STP
configuration is reloaded that was saved off from the switch, an error similar to the following
occurs: Line: 13. Invalid input: stp802.1d Corrupted download file.
18
To Next Page
Loading...
Need help?
General