HP ProDesk 600 G2 Series User Manual

8. To install a new expansion card, hold the card just above the expansion socket on the system board then
move the card toward the rear of the chassis (1) so that the bottom of the bracket on the card slides into
the small slot on the chassis. Press the card straight down into the expansion socket on the system
board (2).
NOTE: When installing an expansion card, press rmly on the card so that the whole connector seats
properly in the expansion card socket.
9. Rotate the slot cover retention latch back in place to secure the expansion card.
10. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if
needed.
11. Replace the computer access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the computer access panel was removed.
14. Recongure the computer, if necessary.
30 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis

HP ProDesk 600 G2 Series Specifications

General

Processor Options	Intel Core i3, Intel Core i5, Intel Core i7 (6th Gen)
Memory	Up to 64 GB DDR4
Storage Options	HDD, SSD
Graphics	Intel HD Graphics, Optional discrete graphics
Ports	USB 3.0, USB 2.0, DisplayPort, VGA, RJ-45
Form Factor	Small Form Factor (SFF), Mini Tower (MT)
Operating System	Windows 10 Pro, Windows 7 Professional
Expansion Slots	PCIe x16, PCIe x1, PCI
Power Supply	200W
Dimensions	Varies by form factor
Weight	Varies by form factor