Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the security
screw:
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the access panel (Access panel on page 20).
3. If you do not have a 6-32 standard screw, remove one of the four silver 6-32 standard screws located on
top of the drive cage. Refer to Drives on page 33 for an illustration of the 6-32 standard screw
locations.
4. Install the 6-32 security screw through the middle front bezel release tab to secure the front bezel in
place.
22 Chapter 4 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
