Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 22).
4. Remove the drive cage (Drive cage on page 25).
5. From the outside, front of the chassis, remove the Phillips screw that secures the speaker to the chassis.
6. On the inside of the chassis, disconnect the speaker cable from the system board connector labeled
SPKR.
52 Chapter 4 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
