Antennas
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 22).
4. Remove the drive cage (Drive cage on page 25).
5. Disconnect the antennas from the WLAN module (M.2 WLAN module on page 48).
6. On the front of the computer, remove the Torx screw that secures the antenna to the computer.
7. On the rear of the computer, squeeze the cover and remove it from the computer.
Antennas 59
To Next Page
Loading...
