Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1. Prepare the computer for disassembly (
Preparation for disassembly on page 85).
2. If the computer is on a stand, remove the computer from the stand.
3. Remove the access panel (
Access panel on page 86).
4. Remove the front bezel (
Front bezel on page 87).
5. Remove one of the five silver 6-32 standard screws located on top of the drive cage.
88 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
To Next Page
Loading...
