Contents 51
Figure 25 Fastening the non-hot-plug hard drive disk to the carrier
To install a non-hot-plug hard drive in the server:
1. Remove the hard drive blank from front of system if installed.
2. Push the hard drive assembly into the drive bay until it stops.
3. Fasten the screw with the T-15 wrench provided to secure the hard drive to the chassis.
4. Connect the cabling from the HDD backplane to the drive using the cables provided.
Figure 26 Installing the non-hot-plug hard drive assembly
To remove the non-hot-plug hard drive:
1. Loosen the screw with the T-15 wrench provided.
2. Pull the hard drive assembly out of the drive bay.
To Next Page
Loading...
