Contents 56
System board configuration
Processor
The HP ProLiant DL160 G5 Server supports dual and quad core processors. If a single CPU is
installed, then use socket 0.When two processors are used, the server supports boot functions through
the processor installed in processor socket 0.However, if processor 0 fails, the system can’t boot up,
and if processor 1 fails, the system will automatically boots from processor 0 and provides a
processor failure message.
The processor socket supports Quad-Core Intel Xeon processor.
CAUTION: It is recommended to use processors of same speeds or cache sizes to prevent possible
server malfunction.
Figure 34 Processor locations
Item Description
1 Processor 1
2 Processor 0
WARNING: To reduce the risk of personal injury from hot surfaces, allow the heat sink and the
processor to cool before touching them.
NOTE: Before installing the processor, remove the air baffle.
To remove the air baffle:
1. Gently rock the air baffle up.
2. Take the air baffle out from the chassis.
To Next Page
Loading...
