Contents 70
Figure 57 Securing the PCI cage
4. Connect the necessary cable(s) to the board.
System battery
The server uses nonvolatile memory that requires a battery to retain system information when power is
removed.
This 3-volt lithium coin cell battery is located on the system board.
Figure 58 System battery location
ARNING: Note the following reminders when replacing the system battery:
• Replace the battery with the same type as the battery recommended by HP. Use of another
battery may present a risk of fire or explosion.
• A risk of fire and chemical burn exists if the battery is not handled properly. Do not disassemble,
crush, puncture, or short external contacts, or expose the battery to temperatures higher than
60°C (140°F).
• Do not dispose of used battery in water or fire. Dispose of used batteries according to
To Next Page
Loading...
