Contents 75
Figure 65 Hot-plug power supply unit
To remove the hot-plug power supply:
1. Disconnect the power cable connecting the hot-plug power supply and the mother board.
2. Press the purple colored handle.
3. Slide the hot-plug power supply out of the power supply bay.
Figure 66 Removing the hot-plug power supply
To replace the hot-plug power supply:
1. Align the hot-plug power supply cage connector with the open slot of power supply, and slide
the hot-plug power supply into the power supply bay until it snaps into place.
2. Snap the latch cover over port colored handle. Latch cover only installs one way.
To Next Page
Loading...
