Removal and replacement procedures 54
Optical disc drive bay
The Optical disc drive bay of servers with 8 3.5-inch HDDs, 8 2.5-inch HDDs and 12 3.5-inch HDDs
support the optional installation of a 12.7 mm (0.5 in.) optical disc drive, so the following procedure
is for servers with 8 3.5-inch HDDs.
To remove the optical disc drive:
1. Remove the top cover.
2. Unplug the SATA and power cables.
3. Loosen the screws.
Figure 9 Removing the Cables and Screws
4. Push the optical disc drive toward the front of the unit.
5. Pull the optical disc drive out of the chassis.
Figure 10 Removing the Optical disc drive
To Next Page
Loading...
