Removal and replacement procedures 55
IMPORTANT: If you remove an optical disc drive without plans of installing a new one, you must
reinstall the blank to maintain proper system airflow.
To remove the bezel blank:
1. Poke the hook of the bezel blank with a T-10/15 wrench through the round hole on the top side
of the HDD cage.
2. Pull the bezel blank out of the bezel.
CAUTION: Do not discard the bezel blank. If the optical disc drive is removed in the future, you must
reinstall the bezel blank to maintain proper system function.
Figure 11 Removing the Bezel Blank
To Next Page
Loading...
