Removal and Replacement Procedures
2-28 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
AC Power Cord and Filter
To remove the AC power cord and filter:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” earlier in this
chapter.
4. Loosen the thumbscrew that secures the AC power cord and filter
.
5. Slide the power cord retaining clip upward to free the AC power cord
.
6. Slide the AC power cord and filter free of the server and lay it over the edge of the
chassis
.
1
3
2
Figure 2-23: Loosening the AC power cord and filter
To Next Page
Loading...
