HP ProLiant DL360 - Utilities Access

Diagnostics and Troubleshooting
4-6 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Utilities Access
The Compaq SmartStart and Support Software CD contains the SmartStart program and
many of the Compaq utilities needed to maintain the system, including:
• System Configuration Utility
• Array Configuration Utility
• Array Diagnostic Utility
• ROMPaq Firmware Upgrade Utilities
• Compaq Diagnostics
CAUTION: Do not select the Erase Utility when running the SmartStart and Support
Software CD. This will result in data loss to the entire system.
Running Compaq Utilities
There are three ways to access Compaq utilities:
Running the Utilities on the Compaq System Partition
If the system was installed using SmartStart, the Compaq utilities will automatically be
available on the Compaq system partition. The Compaq system partition could also have been
created during a manual system installation.
To run the utilities on the Compaq system partition, start the system and press the F10 key
when you see:
Press F10 for Compaq system partition utilities.
Then select the desired utility from the menu:
• The System Configuration Utility is available under the System Configuration menu.
• The Array Configuration Utility is available under the System Configuration menu.
• Compaq Diagnostics (Test and Inspect) are available under the Diagnostics and Utilities
menu.
• The ROMPaq Firmware Upgrade Utility is available under the Diagnostics and Utilities
menu.