HP ProLiant DL360 - Page 73

Diagnostics and Troubleshooting
4-10 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
172-Configuration
Nonvolatile
Memory Invalid
None Nonvolatile configuration
corrupt or jumper installed
Run the System Configuration
Utility and correct.
177-Configuration
Not Complete
None Incomplete system
configuration
Run the System Configuration
Utility and correct.
178-Processor
Configuration
Invalid
None Processor type or step
does not match
configuration memory.
Run the System Configuration
Utility and correct.
180-Log
Reinitialized
None N/A N/A
201-Memory
Error
None RAM failure Run Diagnostics. Replace
failed assembly as indicated.
203-Memory
Address Error
None RAM failure Run Diagnostics. Replace
failed assembly as indicated.
207-Invalid
Memory
Configuration -
Check DIMM
[SIMM]
Installation
None Memory module installed
incorrectly.
Verify placement of memory
modules.
208-Invalid
Memory Speed -
Check DIMM
[SIMM]
Installation
1 long, 1 short The speed of the memory is
too slow:
• Xx00 = expansion
board SIMMs are too
slow
• 00yy = system board
SIMMs are too slow.
• xx and yy have a
corresponding bit set.
The speed of the memory
modules must be 60 ns. Verify
the speed of the memory
modules installed and replace
if slower than 60 ns.
209-Memory
Detection Failure.
Check Memory
Installation
1 long, 1 short Unable to size memory Check DIMM installation and if
error persists, call Compaq
service provider.
continued