HP ProLiant DL360 - Page 79

Diagnostics and Troubleshooting
4-16 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
* 1726-Slot x
Drive Array –
Array Accelerator
Memory Size
Change Detected
None Indicates array accelerator
configuration has been
updated automatically due
to replacement of array
accelerator (or controller)
with one having different
memory size.
Press the F1 key to resume.
* 1727-Slot x
Drive Array –
New Logical
Drive(s)
Attachment
Detected. If more
than 32 logical
drives, this
message will be
followed by:
Auto-configuratio
n failed: Too
many logical
drives.
None Controller has detected an
additional array of drives
that was attached when the
power was off. The logical
drive configuration
information has been
updated to add the new
logical drives. The
maximum number of logical
drives supported is 32.
Additional logical drives will
not be added to the
configuration.
Press the F1 key to resume.
1729-Disk
consistency
initialization in
progress
RAID 4/5
performance may
be lower until
Auto Reliability
Monitoring has
completed
automatic parity
consistency
initialization.
None This message is normal
following the initial
configuration of RAID 4 or
RAID 5 logical drives. This
POST message will go away
and performance of the
controller will improve after the
parity data has been initialized
by ARM (an automatic process
that runs in the back ground on
the controller.)
1730-Fixed
Disk 0 does not
support DMA
Mode.
None Hard drive error Run the System Configuration
Utility and correct.
1731-Fixed
Disk 1 does not
support DMA
Mode.
None Hard drive error Run the System Configuration
Utility and correct.
continued