HP ProLiant DL360 - Page 81

Diagnostics and Troubleshooting
4-18 Compaq ProLiant DL360 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-2: POST Error Messages continued
Error Code Audible Beeps
Probable Source of
Problem Recommended Action
1768-Slot x Drive
Array-Resuming
logical drive
expansion
process.
None SMART-2 Controller error No action required. Appears
whenever a controller reset or
power cycle occurs while array
expansion is in progress.
1769-Slot x Drive
Array - Drive(s)
disabled due to
failure during
expand.
Select F1 to
continue with
logical drives
disabled.
Select F2 to
accept data loss
and to re-enable
logical drives.
None SMART-2 Controller error.
Data has been lost while
expanding the array;
therefore, the drives have
been temporarily disabled.
Press the F2 key to accept the
data loss and re-enable the
logical drives. Restore data
from backup.
1770-Slot x drive
array critical drive
firmware problem
detected. Please
upgrade firmware
on the following
drive(s) using
Options ROMPaq
(available from
www.compaq.co
m); SCSI port (y)
SCSI ID (x)
(RESUME=F1 or
F2 KEY)
None Needs firmware update The indicated drives are
running firmware that is known
to cause intermittent problems.
Please use the Compaq
Options ROMPaq utility to
upgrade firmware on all drives
to the latest revision. Press the
F1 key or the F2 key to
resume.
1771-Primary
Disk Port
Address
Assignment
Conflict
None Internal and external hard
drive controllers are both
assigned to the primary
address.
Run the System Configuration
Utility and correct.
1771-Primary
Disk Port
Address
Assignment
Conflict
None Internal and external hard
drive controllers are both
assigned to the primary
address.
Run the System Configuration
Utility and correct.
continued