Procedure
1. Power down the server according to Avaya's application instructions.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack
4. Remove the access panel
5. Remove the PCIe riser cage.
a. Flip fasteners up (#1 in following image)
b. Turn fasteners 180 degrees (#2 in following image)
c. Lift cage straight up (#3 in following image)
Figure 5: Removing PCIe riser cage
6. Remove any installed expansion boards.
Note:
If you are not replacing the expansion board, replace the screw into the PCIe riser cage
before installing the PCIe riser cage back into the server.
Internal server components
September 2013 Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server 27
Comments on this document? infodev@avaya.com
To Next Page
Loading...
