7. Remove the PCIe riser board.
a. Remove screws (#1 in following images)
b. Remove board (#2 in following images)
Note:
The x16 PCIe riser board has two screws to remove from the assembly and the x8 PCIe
riser board has three screws to remove from the assembly.
Figure 6: Right side, expansion slot 2 PCIe x16, half-height half-length
Figure 7: Left side, expansion slot 1 PCIe x8, low profile
8. To replace the component, reverse the removal procedure.
Maintaining and Troubleshooting the HP DL360p G8 Server
28 Maintaining and Troubleshooting the HP ProLiant DL360p G8 Server September 2013
Comments on this document? infodev@avaya.com
To Next Page
Loading...
