HP ProLiant DL360p

HP Array Configuration Utility 89
</Array>
<Array ID="B">
<!-- Array Drive Type is SAS -->
<!-- Free space 0 GBytes -->
<!-- 1I:4:6 (72 GB),2I:2:4 (72 GB),2I:2:3 (72 GB),2I:2:2 (72 GB)-->
<Drive>1I:4:6, 2I:2:4, 2I:2:3, 2I:2:2</Drive>
<OnlineSpare>No</OnlineSpare>
<LogicalDrive ID="2">
<Raid>5</Raid>
<Size>52478</Size>
<Sectors>32</Sectors>
<StripeSize>64</StripeSize>
<ArrayAccelerator>Enabled</ArrayAccelerator>
</LogicalDrive>
<LogicalDrive ID="3">
<Raid>5</Raid>
<Size>52478</Size>
<Sectors>32</Sectors>
<StripeSize>64</StripeSize>
<ArrayAccelerator>Enabled</ArrayAccelerator>
</LogicalDrive>
<LogicalDrive ID="4">
<Raid>5</Raid>
<Size>52478</Size>
<Sectors>32</Sectors>
<StripeSize>64</StripeSize>
<ArrayAccelerator>Enabled</ArrayAccelerator>
</LogicalDrive>
<LogicalDrive ID="5">
<Raid>5</Raid>
<Size>52478</Size>
<Sectors>32</Sectors>
<StripeSize>64</StripeSize>
<ArrayAccelerator>Enabled</ArrayAccelerator>
</LogicalDrive>
</Array>
</Controller>
</Config.document>
XML input
XML input follows the same format as the document for XML output (on page 88). Use the same parameter
order as the standard input format.
The following example shows a simple input script in both standard and XML formats.