HP ProLiant ML310e Specification

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on
configurable product offerings and requirements.
NOTE: Factory Integrated Models must start with a CTO Server.
NOTE: FIO indicates that this option is only available as a factory installable option.
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Configuration (choose one of the following configurable models)
HP Models HP ProLiant ML310e Gen8 v2 Non-hot Plug 4 LFF Configure-to-order Server 722445-B21
Factory Integrated Model ships with:
HP Ethernet 1Gb 2-port 332i Adapter
HP iLO Management Engine (standard on shared system NIC)
HP Dynamic Smart Array B120i Controller (RAID 0/1/10)
4 ports for HDD
NOTE: For set up instructions for HP Dynamic Smart Array B120i Controller please refer
to the HP ProLiant ML300 series server user guide.
NOTE: For general information about HP Dynamic Smart Array B120i Controller, please
visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/
dynamicsmartarray/index.html
Non Hot-Plug SAS/SATA 4 port cable
PCA Power Cord
Micro ATX Tower (4U)
HP ProLiant ML310e Gen8 v2 Hot Plug 4 LFF Configure-to-order Server 722446-B21
Factory Integrated Model ships with:
HP Ethernet 1Gb 2-port 332i Adapter
HP iLO Management Engine (standard on shared system NIC)
HP Dynamic Smart Array B120i Controller (RAID 0/1/10)
4 ports for HDD
NOTE: For set up instructions for HP Dynamic Smart Array B120i Controller please refer
to the HP ProLiant ML300 series server user guide.
NOTE: For general information about HP Dynamic Smart Array B120i
Controller, please visit:
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/d
ynamicsmartarray/index.html
Hot-Plug SAS/SATA 4 port cable
PCA Power Cord
Micro ATX Tower (4U)
HP ProLiant ML310e Gen8 v2 Hot Plug 8 SFF Configure-to-order Server 722447-B21
Factory Integrated Model ships with:
HP Ethernet 1Gb 2-port 332i Adapter
HP iLO Management Engine (standard on shared system NIC)
Standup HP Smart Array Controller or Host Bus Adapter required
PCA Power Cord
Micro ATX Tower (4U)
QuickSpecs
HP ProLiant ML310e Generation 8 (Gen8) v2
Configuration Information - Factory Integrated Models
DA - 14564 Worldwide — Version 11 — December 13, 2013 Page 17

HP ProLiant ML310e Specifications

General

Bus type	DMI
Stepping	C0
FSB Parity	No
Scalability	1S
Processor cache	8 MB
Processor cores	4
Processor model	E3-1220V3
System bus rate	5 GT/s
Processor series	Intel Xeon E3-1200 v3
Processor socket	LGA 1150 (Socket H3)
Processor codename	Haswell
Motherboard chipset	Intel® C222
Processor frequency	3.1 GHz
Processor cache type	Smart Cache
Processor lithography	22 nm
Processor manufacturer	Intel
Processor package size	37.5 x 37.5 mm
Processor front side bus	- MHz
Processor boost frequency	3.5 GHz
Processor operating modes	64-bit
ECC supported by processor	Yes
PCI Express configurations	1x8, 1x16, 2x4, 2x8
Supported instruction sets	AVX 2.0, SSE4.1, SSE4.2
Thermal Design Power (TDP)	80 W
Number of processors installed	1
Thermal solution specification	PCG 2013D
Maximum number of PCI Express lanes	16
Memory types supported by processor	DDR3-SDRAM
Memory channels supported by processor	Dual
Memory clock speeds supported by processor	1333, 1600 MHz
Memory bandwidth supported by processor (max)	25.6 GB/s
Maximum internal memory supported by processor	32 GB
HDD size	3.5 \
HDD speed	7200 RPM
RAID levels	0, 1, 10
HDD interface	Serial ATA III
Optical drive type	DVD-RW
Total storage capacity	1000 GB
Maximum storage capacity	16 TB
Supported storage drive interfaces	SAS, Serial ATA
Internal memory	4 GB
Memory clock speed	1333 MHz
Memory layout (slots x size)	1 x 4 GB
Maximum graphics card memory	16 MB
On-board graphics card model	Not available
Graphics card	G200
Graphics card family	Matrox
Intel® Virtualization Technology (Intel® VT)	VT-d, VT-x
Cabling technology	10/100/1000Base-T(X)
Ethernet interface type	Gigabit Ethernet
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	2
PCI Express slots version	3.0
Operating system installed	-
Compatible operating systems	Windows Server\\r Ubuntu\\r Red Hat Enterprise Linux\\r SUSE Linux Enterprise Server\\r VMware
Noise level	26 dB
Chassis type	Tower (4U)
Power supply	350 W
Power supply input frequency	47/63 Hz
Certification	FCC; CISPR 22; EN55022; EN55024; FCC CFR 47; ICES-003; CNS13438; GB9254; K22; K24; EN 61000-3-2; EN 61000-3-3; EN 60950-1; IEC 60950-1
Processor ARK ID	75052
Intel Identity Protection Technology version	1.00

Weight and Dimensions

Depth	475.2 mm
Width	175 mm
Height	368.2 mm
Weight	18960 g