Removal and replacement procedures 34
2.
Install the half-height media device.
3. Connect the power cable and the SATA cable to the rear of the drive.
4. Install the access panel.
5. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
6. Power up the server.
Full-height media device
To remove the component:
1. Power down the server (on page 25).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Bezel" on page 27).
o Remove the server from the rack (on page 26).
3. Remove the access panel ("Access panel" on page 29).
4. Disconnect the cables from the rear of the full-height media device.
To Next Page
Loading...
