Error messages 95
207-Memory Configuration Warning - DIMM In Socket x does not have Primary Width of 4 and
only supports standard ECC
Advanced ECC does not function when mixing DIMMs with Primary Widths of x4 and x8.
Audible Beeps: 1 long, 1 short, or none
Possible Cause: Installed DIMMs have a primary width of x8.
Action: Install DIMMs that have a primary width of x4 if Advanced ECC memory support is required.
209-Online Spare Memory Configuration - No Valid Banks for Online Spare
Audible Beeps: 1 long, 1 short
Possible Cause: Two valid banks are not available to support an online spare memory configuration.
Action: Install or reinstall DIMMs to support online spare configuration.
209-Online Spare Memory Configuration - Spare Bank is Invalid
Audible Beeps: 1 long, 1 short
Possible Cause: Installed DIMMs for online spare bank are of a size smaller than another bank.
Action: Install or reinstall DIMMs to support online spare configuration.
209-Hot-add Memory Configuration - Boards must be installed sequentially.
Audible Beeps: 1 long, 1 short
Possible Cause: Memory boards are not installed sequentially.
Action: Install or reinstall memory boards sequentially.
209-Mirror Memory Configuration - Memory Sizes on boards X and Y do not match
Audible Beeps: 1 long, 1 short
Possible Cause: The overall size of two boards participating in a mirrored configuration does not
match.
Action: Install or reinstall DIMMs to support mirrored mode.
209-RAID Memory Configuration - Memory Sizes on boards X and Y do not match
Audible Beeps: 1 long, 1 short
Possible Cause: The overall size of two boards participating in a RAID does not match.
Action: Install or reinstall DIMMs to support RAID mode.
210-Memory Board Power Fault on board X
Audible Beeps: 1 long, 1 short
Possible Cause: A problem exists with a memory board powering up properly.
Action: Exchange DIMMs and retest. Replace the memory board if problem persists.
To Next Page
Loading...
Need help?
General
