HP R3000 ERM User Manual

Installing the ERM in a rack
Before installing the unit, review and adhere to all warnings
provided in "Precautions (on page 1)."
WARNING: Uneven mechanical loading in the rack may
cause a hazardous condition
CAUTION: Always plan the rack installation so that the
heaviest item is on the bottom of the rack. Install the
heaviest item first, and continue to populate the rack from
the bottom to the top.
1. Install the mounting rails ("Installing the mounting rails" on
page 2).
2. Install the mounting ears on the chassis using the screws
provided.
3. With one person on each side, lift the chassis to rail level and
slide the chassis on the mounting rails.
4. Attach the chassis to the rack using the supplied screws.
Connecting the battery leads

HP R3000 ERM Specifications

General

Topology	Line Interactive
Rack Height	2U
Power Capacity	3000 VA / 2700 W
Frequency	50/60 Hz
Battery Type	Sealed Lead-Acid
Output Receptacles	IEC 320 C13
Dimensions (H x W x D)	3.5 x 17.2 x 19.5 in (89 x 437 x 495 mm)