Charging the ERM batteries
Connect the UPS to a grounded utility power outlet. When the UPS is
plugged in, the unit automatically enters Standby mode and begins
charging the ERM batteries. Allow 48 hours for the ERM to fully
charge.
Installing the ERM as a tower
Before installing the unit, review and adhere to all warnings
provided in "Precautions (on page 1)."
The tower stands and associated hardware ship with the UPS.
Rotating the logo badge
Gently pull out the logo badge, rotate it 90 degrees, and then
replace it in the bezel.
Attaching the ERM front bezel
Attaching the tower conversion stands
WARNING: To reduce the risk of personal injury or
damage to the equipment, the tower conversion stands
must be properly attached when the unit is installed as a
tower.
1. Using the preinstalled screws, attach the tower conversion
stands to the unit.
2. Remove a screw from the inner-most, rear corner of the UPS
and ERM.
3. To attach the tower brackets:
o For the front bracket, use the mounting ear screws.
o For the rear bracket, use the screws removed from the
chassis.
Continuing the installation
To continue the ERM installation, follow the instructions starting with
"Connecting the ERM to the UPS (on page 5)."
To Previous Page
Loading...
