14. Replace the rear I/O cover by placing the hooks on the bottom of the cover into the slots on the
bottom of the chassis (1). Then rotate the top of the I/O cover up so that it snaps securely onto
the chassis (2).
15. You can adjust the monitor stand height and tilt to a variety of positions. Choose a position that
is the most ergonomically appropriate for your usage.
Routing Cables to External Devices
1. Turn off the computer properly through the operating system, then turn off any external devices.
2. Disconnect the power cord from the power outlet.
CAUTION: Regardless of the power-on state, voltage is always present on the system board
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
Routing Cables to External Devices 13
To Next Page
Loading...
