Chapter 1
Wheel Kit Installation Guide
Wheel Kit Installation
12
Step 2. Slide the cover toward the rear of the chassis.
Step 3. Lift the cover up and away from the chassis.
Installing the New Top Cover
Step 1. Slide the new cover into position. It should easily slide into position; however, a slow firm pressure
will be needed to properly seat the cover.
Step 2. Tighten the retaining screws securing the cover to the chassis.
Removing a Side Cover
Figure 1-9 Side Cover Retaining Screw
Step 1. Loosen the retaining screw securing the cover to the chassis.
To Next Page
Loading...
Need help?
General