HP StorageWorks XP20000/XP24000 - Disk Array - Page 100

DescriptionItem
The suspend type set
P-VOL Failure: Writing to the P-VOL is disabled
S-VOL: Writing to the P-VOL is enabled
Kind
The suspend rage set. This value is output when the asynchronous pair is split
only.
Group: Group (all asynchronous pairs in the consistency group),
LU: LU (specified asynchronous pair only)
Range
The setting of unreflected data handling. This value is output when the
asynchronous pair is split only.
Drain, Purge
Mode
The result of operation
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of split pairsNum. of Pairs
Pairsplit-S Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Cnt Ac],Pairsplit-S,,Normal end,,,Seq.=xxxxxx
+{P-VOL(Port-G-ID-LUN),S-VOL(Port-G-ID-LUN),Type,Force,Range,Result}=
-{1A-0x00-0x000,1B-0x00-0x000,P-VOL,No,Group,Normal End},
{1A-0x00-0x001,1B-0x00–0x001,P-VOL,No,Group,Normal End},
+{1A-0x00-0x002,1B-0x00–0x002,P-VOL,No,Group,Normal End},(snip)
-(snip), Num. of Pairs=xx
[Cnt Ac]
HP XP Continuous Access Software function
Pairsplit-S
Pairsplit-S operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 57.
Table 57 Pairsplit-S Operation
DescriptionItem
The port number, host group number, and LUN of the primary volume in the
deleted pair sequentially
P-VOL (Port-G-ID-LUN)
XP Continuous Access Software Function100