HP StorageWorks XP20000/XP24000 - Disk Array - Page 184

DescriptionItem
Standby SVP details are provided in the format described below.
IPv4 (IP Address: IP address, Subnet Mask: Subnet Mask)
IPv6 (IP Address: IP Address, Subnet Prefix: Subnet Prefix)
S-SVP
IPv4 (IP Address,
Subnet Mask)
IPv6 (IP Address,
Subnet Prefix)
Set Security Switch Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Install],Set Security Switch,,Normal end,,,Seq.=xxxxx
+{Port,Switch}=[{XX,Disable},{XX,Enable}],Num. of Ports=2
[Install]
Install function
Set Security Switch
Set Security Switch operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 151.
Table 151 Set Security Switch Operation
DescriptionItem
The name of the port where the LUN security setting is changed.Port
Indicates whether the LUN security setting is enabled or disabled.
Disable or Enable will appear.
Switch
The number of ports where the LUN security setting is changed.Num. of Ports
Set Speed Mode Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Install],Set Speed Mode,,Normal end,,,Seq.=xxxxx
+CHA=CHA-1E
++{Port Block,Mode}=[{A,High Speed},{B,High Speed}Num. of Blocks=2
+CHA=CHA-1H
++{Port Block,Mode}=[{A,Standard},{B,High Speed}],Num. of Blocks=2
+Num. of CHAs=2
[Install]
Install function
Set Speed Mode
Install Function184