Install function
Set IP Address
Set IP Address operation
SVP&DKC
SVP&DKC is the selected parameter. This operation uses the following parameters, as shown in Table
149.
Table 149 Parameters for Set IP Address Operation
DescriptionParameter
Change of the IP address for SVPSVP
Change of the IP address for SVP and DKCSVP&DKC
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 150.
Table 150 Set IP Address Operation
DescriptionItem
The IP address in SVP.IP Add
The subnet mask in SVP.Subnet
Indicates whether the Duplex setting in SVP is valid or invalid.
Valid: Valid, Invalid: Invalid
Use Duplex
The kind of duplicated SVP.
Master SVP: Master SVP, Standby SVP: Standby SVP.
SVP Kind
The status of IPv4.
Valid: enabled, Invalid: disabled.
IPv4
The subnet mask of IPv6.
Valid: enabled, Invalid: disabled.
IPv6
Master SVP details are provided in the format described below.
IPv4 (IP Address: IP address, Subnet Mask: Subnet Mask)
IPv6 (IP Address: IP Address, Subnet Prefix: Subnet Prefix)
M-SVP
IPv4 (IP Address,
Subnet Mask)
IPv6 (IP Address,
Subnet Prefix)
XP24000/XP20000 Audit Log User and Reference Guide 183
To Next Page
Loading...
