Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 290.
Table 290 Set Auto Plan Param Operation
DescriptionItem
The executed operation.
Default: The default auto migration plan is applied (click the Default button, and then
click the Set button).
Customize: The customized auto migration plan is applied (click the Set button after
changing the value of the auto migration plan parameter).
SetType
Indicates whether the auto migration plan settings are enabled or disabled.
Disable or Enable is output.
PlanSwitch
The specified sampling term.
One of these values is output:
• None
• Every day
• Once every X days (For the value of X, see PlanDay index below)
• Once a week
• Once a month
PlanType
The setting value for sampling term. The output value depends on the sampling term
output to PlanType.
• If None is output to PlanType, nothing is output to PlanDay.
• If Every day is output to PlanType, nothing is output to PlanDay.
• If Once every X days is output to PlanType, the sampling interval is indicated.
• If Once a week is output to PlanType, the specified day of the week is output to
PlanDay. SUN, MON, TUE, WED, THE, FRI, or SAT is output.
• If Once a month is output to PlanType, the specified day from 1 to 31 is output to
PlanDay
PlanDay
The target time zone for the sampling. The left side of the hyphen (-) indicates the start
time of sampling, and the right side indicates the end time.
MonitorPeriod
The target data for making plan (the range of the usage rate that is analyzed by the auto
migration function)
All: All sampling data
XX: The sampling data from the first to 96th.
SampleCount
The number of setting. 1 is always output.Num. of Data
XP24000/XP20000 Audit Log User and Reference Guide 315
To Next Page
