This information displays in the syslog information file only. No parameters display for this event.
[Audit Log]
Audit Log function
Over Threshold
Over Threshold event
Normal end
The operation has ended normally.
Set FTP Server Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[AuditLog], Set FTP Server,,Normal end,
Seq.=xxxxx
+{ServerType,IPAddrVer,OutFlg,SrvAddr,UserName,OutputDir}=[{Primary,IPv4,Disable,
192.168.0.1,root,/Data/AuditLog},
-{Secondary,IPv6,Enable,3ffe:0501:4819:2000:5254:00ff:fedc:50d2,-,-}]
[Audit Log]
Audit Log function
Set FTP Server
Set FTP Server operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
If enabled, detailed information appears for this operation, as shown in Table 15.
Table 15 Set FTP Server Operation
DescriptionItem
The server type of the FTP (File Transfer Protocol) server to be set. If the setting is not
changed, a hyphen (-) is displayed.
Primary: Primary FTP server. Secondary: Secondary FTP server.
ServerType
The version number of the internet protocol. If the setting is not changed, a hyphen (-) is
displayed.
IPv6: Internet Protocol Version 6. IPv4: Internet Protocol Version 4
IPAddrVer
Whether to transfer the audit log information file (audit.log) to the FTP server.
Enable: Transfer audit log information file. Disable: Do not transfer audit log information
file.
OutFlg
The IP address to which the audit log information file is sent. If the setting is not changed,
a hyphen (-) is displayed.
SrvAddr
XP24000/XP20000 Audit Log User and Reference Guide 63
To Next Page
Loading...
