HP StorageWorks XP20000/XP24000 - Disk Array - Page 64

DescriptionItem
The user name to login to the FTP server. If the setting has not changed, a hyphen (-) is
displayed.
UserName
The directory in the FTP server that the transferred audit log information files are stored.
If the setting is not changed, a hyphen (-) is displayed.
OutputDir
Set Syslog Server Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Audit Log],Set Syslog Server,DetailFlg=Enable,Normal end,,,Seq.=xxxxx
+DetailFlg=Enable
+LocationInfo=USP001
+{ServerType,IPAddrVer,OutFlg,SrvAddr,SrvPortNum}=[{Primary,IPv4,Disable,
192.168.0.1,514},
-{Secondary,Enable,IPv6,3ffe:0501:4819:2000:5254:00ff:fedc:50d2,-}]
[Audit Log]
Audit Log function
Set Syslog Server
Set System Log Server operation
Detail Flag=Enable
Enable is the selected parameter. This operation uses the following parameters, as shown in Table
16.
Table 16 Parameters for Set Syslog Server Operation
DescriptionParameter
Detailed information is output to the syslog server.Detail Flag=Enable
Detailed information is not output to the syslog server.Detail Flag=Disable
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
If enabled, detailed information appears for this operation, as shown in Table 17.
Table 17 Set Syslog Server Operation
DescriptionItem
Indicates whether to output detailed information to the syslog server.
Enable: Output detailed information. Disable: Do not output detailed information.
DetailFlg
The location identification information for the storage system. Not output when setting
is not changed.
LocationInfo
Audit Log Function64