Step 3: Create Subnets
1. Select the Port Set and click Add in the Subnet section.
Table 7 Network Configuration New Subnet fields
DescriptionName
The name of the SubnetName
Select IPv4 or IPv6.Protocol
The IP address for the subnet, in the appropriate format
for the protocol selected.
IP address
When checked, this box indicates that this is the Subnet
that contains the default gateway. A default subnet
should be provided for both IPv4 and IPv6 networks.
Default Subnet
The network maskNetwork Mask (IPv4 only)
The network prefix in CIDR formatPrefix (IPv6 only)
The domain nameDomain Name
The VLAN tag ID (2 to 4096)VLAN tag
2. Provide the Subnet details listed in Network configuration subnet fields (page 56), and click
OK.
• For IPv4 Subnets select the IPv4 button and provide the relevant details.
• For IPv6 Subnets select the IPv6 button and provide the relevant details.
• DHCP Subnets may support both IPv4 and IPv6 protocols.
3. Repeat until all the Subnets for the selected Port Set have been defined.
• Each physical Port Set may be configured with one Subnet that uses the IPv4 protocol
and one Subnet that uses the IPv6 protocol.
• If the Port Set is VLAN enabled, it is possible to add a total of 128 VLAN Subnets. These
total values apply across the whole network configuration, not per Port Set.
• If DHCP is used , one IPv4 and one IPv6 subnet will be consumed.
56 Network configuration, how to use the StoreOnce GUI
To Next Page
Loading...
