HP T1000 G3 User Manual

HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S 505922-002
4
Chapter 3 Installation
This section explains:
S Equipment inspection
S UPS internal battery connection
S UPS installation
S UPS rear panels
Inspecting the Equipment
If any equipment has been damaged during shipment, keep the shipping cartons and
packing materials for the carrier or place of purchase and file a claim for shipping
damage. If you discover damage after acceptance, file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with the carrier
within 15 days of receipt of the equipment; 2) Send a copy of the damage claim within
15 days to your service representative.
NOTE: Check the battery recharge date on the shipping carton label. If the date has
passed and the batteries were never recharged, do not use the UPS. Contact your service
representative.
Connecting the UPS Internal Battery
To ensure proper battery operation:
1 Verify that the UPS power is off and unplugged.
2 Pull the top left corner forward and remove the UPS front bezel (see Figure 2).
Figure 2 Removing the UPS Front Bezel

HP T1000 G3 Specifications

General

Topology	Line Interactive
Input Voltage	120V
Output Voltage	120V
Interface	USB
Form Factor	Tower
Output Connections	6 x NEMA 5-15R
Input Connection	NEMA 5-15P
Typical Backup Time at Half Load	10 minutes
Typical Backup Time at Full Load	3 minutes
Efficiency at Full Load	95%
Typical Recharge Time	8 hours
Efficiency	95%
Operating Temperature	0°C to 40°C
Storage Temperature	-15°C to 45°C
Humidity	0-95% non-condensing
Capacity	1000 VA
Battery Type	Sealed Lead Acid
Frequency	50/60Hz
Transfer Time	4-8 ms
Warranty	3-year limited warranty