HP t730 Thin Client User Manual

3. Turn o the thin client properly through the operating system, and then turn o any external devices.
4. Disconnect the AC power cord from the AC outlet, and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as
the system is plugged into an active AC outlet. You must disconnect the AC power cord to avoid damage
to the internal components of the thin client.
5. Remove the stand from the thin client.
6. Lay the unit at on a stable surface with the right side up.
7. Release the latch (1) on the left side of the rear I/O panel, rotate the I/O panel (2) to the right, and then
lift it o the thin client.
8. Move the access panel latch (1) down to release the access panel.
9. Slide the access panel approximately 6 mm (.24 in) toward the back of the chassis, and then lift the
panel o of the thin client (2).
6 Chapter 2 Hardware changes

HP t730 Thin Client Specifications

General

Memory	Up to 16 GB DDR3L-1600 SDRAM
Graphics	AMD Radeon R7E
Networking	Optional Wi-Fi
Ports	1 x RJ-45
Operating System	Windows 10 IoT Enterprise
Weight	1.3 kg
Power Supply	65W external power adapter