HP t730 Thin Client User Manual

Removing and replacing the M.2 ash storage module
To remove the M.2 ash storage module:
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB ash drives, from the thin client.
3. Turn o the thin client properly through the operating system, and then turn o any external devices.
4. Disconnect the AC power cord from the AC outlet, and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as
the system is plugged into an active AC outlet. You must disconnect the AC power cord to avoid damage
to the internal components of the thin client.
5. Remove the stand from the thin client.
6. Lay the unit at on a stable surface with the right side up.
7. Remove the thin client access panel. See Removing and replacing the access panel on page 5.
8. Locate the M.2 socket for ash storage module on the system board. See Locating internal components
on page 8.
9. Loosen the screw securing the ash storage module until the end of the module can be raised.
10. Pull the ash storage module out of the socket.
Removing and replacing the M.2 ash storage module 9

HP t730 Thin Client Specifications

General

Memory	Up to 16 GB DDR3L-1600 SDRAM
Graphics	AMD Radeon R7E
Networking	Optional Wi-Fi
Ports	1 x RJ-45
Operating System	Windows 10 IoT Enterprise
Weight	1.3 kg
Power Supply	65W external power adapter