Button Function
Green Opens the green Fasttext shortcut link when display is in Teletext mode.
Yellow Opens the yellow Fasttext shortcut link when display is in Teletext mode.
Blue Opens the blue Fasttext shortcut link when display is in Teletext mode.
Troubleshooting the remote control
If the remote control doesn't work:
●
Make sure that the batteries for the remote control are charged and installed correctly.
●
Make sure the front of the remote sensor (IR receiver) is not blocked.
●
If a pressed key repeats itself or sticks, try altering the lighting conditions in the room, moving
the location of the remote sensor if this continues.
●
Press the Enter button on the remote control after changing a channel.
●
Point the remote control toward the remote sensor, and press a button. A faint light should
appear on the remote sensor. If the light appears, then the problem is with the software. Close
the software, restart the computer, and open the software again.
●
If the remote control works in the software but not when changing channels, you need to
reconfigure the software setting for the cable set-top box or satellite receiver.
14 Chapter 3 Using the remote control ENWW
To Next Page
Loading...
