HP X32 User Manual

26 pages

To Next Page

To Previous Page

2) Use a hot air gun to melt the solder on the pins.

3) Lift the J2 connector from the PCB.

4) Place the new component on the PCB. Be sure that it matches the PCB footprint.

5) Solder the new component.

DP connector J3

Repair the DP connector:

1) Use a soldering iron and a desoldering pump to remove as much solder as possible from the pin.

Questions and Answers:

Need help?

Do you have a question about the HP X32 and is the answer not in the manual?

General