78 REMOVAL AND REPLACEMENT PROCEDURES
Front Panel I/O Device Assembly
1 Disconnect power from the system (page 68), remove the access panel (page 74), and remove the
front bezel (page 75).
2 Unlatch the plastic snap that secures the cables inside the chassis and disconnect the front panel I/O
device assembly cables from the system board.
3 Remove the screws that hold the front panel I/O device assembly and bracket to the chassis and
remove the screws that hold the front panel I/O device assembly to the bracket.
4 Pull the front panel I/O device assemblyout about two inches away from the chassis.
5 Separate the bracket away from the front panel I/O device assembly.
WARNING! The next step requires the removal of cables through the chassis. Some edges on the
chassis might be sharp. Be careful when removing these cables.
6 Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel I/O device assembly, reverse the previous steps.
To Next Page
Loading...
