HP Xw6200 - Workstation - 2 GB RAM User Manual

94 REMOVAL AND REPLACEMENT PROCEDURES
Battery
CAUTION Before removing the battery, be sure your CMOS settings are backed up as all CMOS
settings are lost when the battery is removed. To back up the CMOS settings, use Computer Setup and
run the Save to Diskette option from the File menu.
1 Disconnect power from the system (page 68), remove the access panel (page 74), and lay the
workstation on its side with the system board facing up.
2 On the system board, press on the release tab of the battery holder.
3 Rotate the battery enough to get beyond the latch and lift it straight up.
To install the battery slide the battery back in until it snaps back into place.

HP Xw6200 - Workstation - 2 GB RAM Specifications

General

Model	Xw6200
RAM	2 GB
Form Factor	Tower
Chipset	Intel E7525
Category	Workstation
Graphics	Integrated or dedicated (specific model varies)
Product Type	Desktop
Audio Output	Integrated sound card
Networking	Integrated Ethernet
Processor Socket	Socket 604
Optical Drive	DVD-ROM, DVD-RW
Expansion Slots	PCI, PCI-X
Ports	USB, serial, parallel, audio, Ethernet
Operating System	Microsoft Windows XP Professional, Microsoft Windows XP Home